Attempting to click RDP bookmark for ActiveX causes session to open and...
Hello,When a client of mine tries to open an RDP bookmark (ActiveX), there are several popups, then they all instantly close. I've tried disabling popup blocker, adding the site to the trusted sites...
View ArticleClik here to view.
Best Practices: GMS and Analyzer - Getting the most out of Reports.
Best Practices: GMS and Analyzer - Getting the most out of Reports.
View ArticleNSA 3600 - Configuration not saved when new routes added from WEB GUI
I experienced this last night and it is easy to reproduce (at least on my NSA 3600).When I add a route using GUI (static route over VPN tunnels) the route works and traffic flows as expected. But...
View ArticleLog tuning - removing unwanted noise (alerts I don't want to see)
I want the firewall to keep blocking all the google analytics and other similar sites, but I don't want them logged, it's just noise to me. Unfortunately the category, under ID 14, is also where all...
View ArticleTwo Sonicwalls one WAN connection
HiI would like to reduce my WAN connections in my company. Currently I have three. A litte explanation: I have two department buildings with each their own sonicwall. One sonicwall has two WAN...
View ArticleSonicWall ViewPoint out of support issue
I renewed my SonicWall license from about 3 months and it contain viewpoint support , and I want to use this feature , but the Dell stated that it is out of support , is this mean that I can not use...
View ArticleOSPF Full / PTP-Unnumbered
Hi there,I've setup tunnel interface VPN between tz205 & NSA E5500 and enabled OSPF on both system. Tunnel is up and OSPF seems populating remote site network info on routing section.Although...
View ArticleSetting a single ISP to VOIP
Good afternoon and thank you very much in advanced for the help i could receive from this community, I have a NSA 220 in it we have 4 differents isp connections and right know we have more than 20 VOIP...
View ArticleEncryption errors with Firefox 38 and TZ 205
My TZ 205 is using firmware SonicOS Enhanced 5.9.0.7-17o. When I log in to the management interface, it works UNTIL I access the Log->Settings section, then I get an error:An error occurred during...
View Article2 sonicwalls on the same subnet strange behavior
soo.. I have 2 sonicwalls in our data center. we have a block of 30 IP addresses we can use. for the sake of simplicity we can use 10.0.0.2-10.0.0.31 with a gateway of 10.0.0.1sonicwall 1 is configured...
View ArticleRe-run setup Wizard
My environment is changing. What is the easiest way to re-run the setup wizard?
View ArticleSonicOS under development or not?
There has not been a new General Availability release since before Dell acquired SonicWall, and no early release since December of 2014 - closing in on 6 months. Every release in the 5.9 series has had...
View ArticleMonitor changes to NSA 3500 configuration?
Is there a way to monitor changes to the Sonicwalls configuration? or a third party app that can do this?
View ArticleClik here to view.
NSA 4600 HA question
Hello,I am currently running HA on our network on an NSA 4600 and everything is fine on that point. On Monday I am going to be upgrading to the new firmware for the first time with the HA intact. I...
View ArticleDatabase Healthcheck alert on Analyzer
I've started to receive alert emails from my Analyzer stating that the database current size is 438.95 MB. Yet when I look in Analyzer status I don't see anything indicating this size. Is there...
View ArticleSonicwall TZ300 sans diagnostic util menu?
I have seen mention of the ability to do a variety of things from within Sonicwall such as performing a traceroute, ping etc. Yet when I login to a TZ300 with SonicOS Enhanced 6.2.3.1-19n I see no such...
View ArticleDHCPv6 Server received message (MSG_SOLICIT) filling up logs
I have a client with a TZ300 with SonicOS Enhanced 6.2.3.1-19n and some device on X0 are causing a DHCPv6 Server received message (MSG_SOLICIT)every minute or so. There is no DHCPv6 server on the...
View ArticleFiber WAN instead of X1
I have a N3600 Sonic Wall. I have a fiber handoff from the ISP. I have an SFP plugged into the X14 port. How do I make this my default WAN gateway? Can I configure the port to auto negotiate?
View ArticleSyslog entry for modifiying address object?
Hello,is there an option to log modification of address objects 8specifically groups)? I can log when an access rule changes, but also would need to know if the objects in the rules get changed. While...
View Article